Universeal Slate Sealer (Water Based) - 1 litre
Buy 2 or more save 5%
@ £14.25 £17.10 each
Buy 5 or more save 8%
@ £13.80 £16.56 each
Hard-wearing Surface Coating
Universeal Slate Seal is a hard wearing surface sealer which leaves the slate looking vibrant and shiny. The colour structure of the slate is intensified; the surface develops a “wet glossy look” It offers high quality stain protection as well as beautifying the natural colours of the slate. This treatment prevents water and dirt from penetrating into the surface, making it easier to clean and maintain.
- Hard Wearing Satin Finish
- Intensifies Natural Colours
- High Quality Stain Protection
- Indoor & Outdoor Use
- IMPORTANT - Always follow the instructions on the label carefully regarding suitability
We Recommend Instead of:
- Lithofin Slate Seal
Up to 15m2 per litre. Coverage will vary depending on surface porosity.
Directions for use:
The surface to be treated must be completely dry and clean. Apply Universeal Slate Seal evenly with a clean roller or brush. In the case of highly absorbent surfaces, it may be necessary to apply a second coat. Application Temperature: the temperature of the surface should be between 5°C and 25°C. Switch off under floor heating prior to application. *Drying Time: Light foot traffic after approx 45-60 minutes, completely dry / cured after 48 hours. Avoid cleaning and spillages for 48 hours after application.
Universeal Slate Seal is not suitable for use on non-absorbent, polished or very finely honed surfaces. Please take extra care when using around surfaces that may be sensitive to solvents If necessary, Universeal Slate Seal can be removed from the applied surface using Universeal Pro-Strip. Please ensure that no moisture can penetrate into the sealed surface, and that moisture can not be transported through the sides or the surface from the ground. Moisture inside the stone will cause the sealant to turn white if not already fully cured.